Comment:	ARI Santa Maria a Monte IQ5QD {UIV32N}
Last status:	UI-View32 V2.03
Last beacon:	[JN53IR]
Location:	43°44.21' N 10°40.41' E - locator JN53IR06TU - show map 4.3 km North bearing 343° from Santa Maria a Monte, Provincia di Pisa, Tuscany, Italy [?] 5.5 km Northeast bearing 52° from Bientina, Provincia di Pisa, Tuscany, Italy 46.4 km West bearing 266° from Florence, Provincia di Firenze, Tuscany, Italy 99.5 km Southwest bearing 212° from Bologna, Provincia di Bologna, Emilia-Romagna, Italy
Last position:	2026-02-10 20:57:51 UTC (1m19s ago) 2026-02-10 21:57:51 CET local time at Santa Maria a Monte, Italy [?]
Device:	Roger Barker, G4IDE: UI-View32 (software, Windows)
Last path:	IQ5QD-10>APU25N via RELAY,WIDE2-1,WIDE1-1,qAR,IR5X This station is transmitting packets with a configured path of over 3 digipeaters. This causes serious congestion in the APRS network and errors when plotting the station's route on a map. Please consider using a path of WIDE1-1,WIDE2-1 or WIDE2-2, or even WIDE1-1,WIDE2-2 if you are moving very far away from an iGATE. If WIDE1-1 is used in the path, it should be the first component of the path, so that a fill-in digipeater would be the first one to retransmit the packet. It would be advisable to replace RELAY with WIDE1-1. WIDE1-1,WIDE2-1 is generally a good path.
Positions stored:	6
Other SSIDs:	IQ5QD-13 IQ5QD
APRS igate – Statistics for 2026-02:
Stations heard directly:	10 on radio path – show map
Last heard a station directly:	2026-02-10 19:57:04 UTC (1h2m ago)
Position packets heard directly:	29 on radio path
Position packets sent to APRS-IS:	39 – show map

Only position packets which were originated by the station are shown here. The range statistics show some extra long hops, because some digipeaters do not correctly add themselves to the digipeater path. Please check the raw packets.

Only stations from which a position packet has been heard are shown here. The range statistics show some extra long hops, because some digipeaters do not correctly add themselves to the digipeater path. Please check the raw packets.

This page shows real-time information collected from the Automatic Position Reporting System Internet network (APRS-IS). APRS is used by amateur (ham) radio operators to transmit real-time position information, weather data, telemetry and messages over the radio. A vehicle equipped with a GPS receiver, a VHF transmitter or HF transceiver and a small computer device called a tracker transmits it's location, speed and course in a small data packet, which is then received by a nearby iGate receiving site which forwards the packet on the Internet. Systems connected to the Internet can send information on the APRS-IS without a radio transmitter, or collect and display information transmitted anywhere in the world.